Skip to main content
All integrations
Smart Tooling

Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) + Ignite Lean

Available now

Bench scales verify by weight, error-proofing kit and lot picks. Stream weight data to builds.

REST API Webhooks

How the Connection Works

Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix)
REST APIWebhooks
Ignite Lean
Into Ignite Lean
  • Weight readings
Back to Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix)
  • Target weight + tolerance

How It Works

  1. 1Scales publish weight via REST / serial.
  2. 2Ignite Lean compares to target and raises an NC if out of tolerance.
  3. 3Target weight pushes back as part of the build.

Recommended Workflows

How Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) works best with Ignite Lean. These are recommended patterns: Ignite Lean fires the trigger, and how Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) routes it (which work group, which device, which rule) is configured to your IT setup.

Torque trace attaches to the build
Trigger An operator runs a tightening cycle
  1. 1Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) executes the tightening with the right program.
  2. 2Torque, angle, and NOK results post to Ignite Lean.
  3. 3Each fastener attaches to the build for traceability.
Full torque traceability on every unit, no paper records.
Sequence enforcement prevents skips
Trigger An operator builds a multi-fastener assembly
  1. 1Ignite Lean pushes the active sequence to Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix).
  2. 2Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) only allows the next fastener in sequence.
  3. 3Skips raise NCs immediately.
Sequence violations become impossible, not just discouraged.

Connect Industrial Scales (Mettler-Toledo, Avery Weigh-Tronix) today

This works now through our REST API, outbound webhooks, and Excel/CSV. Start with the API reference, or talk to us about a guided setup.

API ReferenceTalk to Us